Sink, Basin & Vanity Installation Bayswater & Eastern Suburbs
We install kitchen sinks, bathroom basins and vanity units for homes across Bayswater and Melbourne's eastern suburbs. Whether it is a quick like-for-like swap or a new fit-out as part of a renovation, we get the plumbing in properly so it drains cleanly and stays leak free.
- Swaps & Full Fit-Outs From a single like-for-like basin swap to a full kitchen or bathroom fit-out, we handle the plumbing side properly.
- Trusted By Homeowners With over 160 5-star reviews, our satisfied customers speak for us.
- Licensed & Fully Insured Every install is carried out by a licensed plumber. Upfront pricing before any work begins.
A sink or basin is only as good as the plumbing behind it
A new sink or basin looks great until the connection underneath starts to weep, the trap is set up wrong and the bowl drains slowly, or the seal lets go and water tracks into the cabinet below. The fitting at the front is the easy part. The hot and cold supply, the drain, the trap and the waste behind it are what decide whether it lasts.
Common reasons people in Bayswater call us for sink, basin and vanity work:
- Old kitchen sink or basin cracked, stained, or past its best
- Like-for-like swap to a newer model or finish
- New vanity unit going into a bathroom
- Kitchen or bathroom renovation needing the plumbing done at the right stage
- Slow draining bowl from a poorly set up trap or waste
- Leak under the sink from a DIY connection that was not quite right
Whatever the reason, we can usually talk through the job over the phone and give you a quote before we arrive.
Swaps, new vanities and renovation fit-outs done right
Most of the work falls into two types. A like-for-like swap, where the supply and waste are already in the right place and we lift the old sink or basin out, set the new one in, reconnect the hot and cold supply, refit the trap and waste, and reseal it to the bench or wall. Or a new fit-out, where a vanity unit goes in fresh or the layout changes and we run or move supply and waste lines to suit.
On a full kitchen or bathroom renovation we work alongside the carpenter and tiler so the rough-in goes in at the right stage and the final connection lands once the cabinetry and benchtop are set. We seal the sink or basin properly so it does not move or weep. If you also need a dishwasher, washing machine or fridge line connected, we cover that on our appliance connections page.
- Kitchen sink installation and replacement
- Bathroom basin and vanity unit installation
- Like-for-like swaps and new renovation fit-outs
- Hot and cold supply, drains, traps and wastes fitted
- Sink or basin sealed to the bench or wall
- Upfront pricing, no surprises on the day
Trusted by over 160 melbourne home owners
- Carla D Home Owner
Jason is a reliable plumber, super responsive and arrives on time. there were a few logistical issues in our old 1970s bathroom renovation and he was honest about what could reasonably be done and worked within our budget. Our go-to guy for plumbing!
- Holly S Home Owner
Upon getting in touch with Jason from McPherson Plumbing & Maintenance, he promptly dispatched his wonderful team to address both issues in just a matter of days. I cannot speak highly enough of this group. It is reassuring to know that Jason and his team are dedicated to going above and beyond, all while offering fair pricing.
- Carlos R Home Owner
Jason is very professional and always very honest about his work. We were very happy with his work. We did a big bathroom and kitchen renovation and he did all the plumbing for us.
Get a Quote for Sink, Basin & Vanity Installation in Bayswater
Whether you need a kitchen sink swapped, a bathroom basin fitted, or a new vanity installed as part of a renovation, get in touch. We can talk through the job over the phone and give you a quote before we arrive.
- Phone 0407 696 994
Over 160 5-Star reviews from eastern suburbs homeownersLocal to Bayswater, with the experience to get it right
McPherson Plumbing is based in Bayswater North and installs sinks, basins and vanities across Melbourne's eastern suburbs, including Knox, Boronia, Heathmont, Wantirna, Ringwood, and surrounding areas. This kind of work is part of our everyday job, from one-off swaps to full renovation fit-outs.
Sink, basin and vanity work covers a lot of our home plumbing jobs. We know how to set up a trap and waste so a bowl drains cleanly, how to seal a basin so it does not weep, and how to work in with the carpenter and tiler so the plumbing lands at the right stage of a reno. If a worn fitting or a slow drain is holding things up, we also handle tap repairs while we are there.
We quote before we start and give you honest advice on what the job actually needs. If it is a simple swap, we will tell you. No upsell.
Why locals choose us for sink, basin and vanity installation
- Like-for-like swaps usually done in a single visit
- Sinks and basins sealed and set so they do not weep or move
- Fully licensed and insured for all plumbing work
- Upfront quotes, no hidden charges
- Kitchen sinks, bathroom basins and vanity units fitted
Like-for-like swaps usually done in a single visitSink, Basin & Vanity Installation FAQs
It depends on the job. A like-for-like swap where the supply and waste are already in the right place is a small, quick job we can usually quote over the phone. A new fit-out where supply or waste lines need moving, or a full vanity unit goes in, takes longer and we will price that work before we start. Either way you get an upfront quote with no surprises on the day.
Yes. We work alongside the carpenter and tiler so the plumbing goes in at the right stage of a kitchen or bathroom renovation. We connect hot and cold supply, fit drains, traps and wastes, and seal the sink or basin to the bench or wall so it does not move or weep.
Yes, and they are some of the most common jobs we do. If your old sink or basin is cracked, stained or just dated, and the supply and waste are already in the right spot, we can swap in the new one, reconnect the supply, refit the trap and waste, and reseal it, usually in a single visit.
For a connection that does not weep and a bowl that drains cleanly, yes. A trap set up at the wrong fall, a waste that is not seated right, or a seal that lets go is a common cause of water tracking into the cabinet below. A licensed plumber sets it up properly so it is done once and stays put.
A like-for-like swap is usually a single visit and done in a couple of hours. New installs that involve moving supply or waste lines, or fitting a full vanity unit, take longer. We confirm the expected timeframe when we quote the job.
Yes. We cover Melbourne's eastern suburbs, including Knox, Boronia, Heathmont, Wantirna, Ringwood, Ferntree Gully, and surrounding areas. If you are not sure whether we cover your suburb, give us a call.